Effect of Voltage Source Differences on Hydrogen Gas Production by Electrolysis-photocatalysis Reactor Systems

Open

F. Maulana, Y. Engge, M. Nurhuda, Istiroyah

2022 IOP Conference Series: Earth and Environmental Science Vol. 1097 Issue 1 Conference paper Cited by 1 Quartile

Abstract

We have evaluated the process of watersplitting into hydrogen gas. Electrolysis-photocatalysis reactor is used to harvest hydrogen gas through water splitting, a combination of electrolysis and photocatalysis reactions. The concentration of hydrogen gas (H2) is detected by the MQ-8 sensor and the number of bubbles is calculated. Evaluation of watersplitting is done by varying the DC voltage source (3V, 6V, 9V, 12V). We found the highest concentration of H2 gas was produced at 12 volts 616300 ppm for 600 seconds, The largest increase from the photocatalyst-electrolysis reaction combination was found to be 182017 ppm. Here we observe a linear increase in hydrogen with increasing voltage which results in a faster electrolysis process. But what is most interesting is the increase in H2 during the simultaneous electrolysis-photocatalysis process. the combined reaction has increased the amount of hydrogen greater than the sum of the photocatalytic and electrolysis reactions taking place separately. It is most likely that a mutually reinforcing reaction occurs so that the overall activation energy of the system becomes smaller in the process of dissociating water into hydrogen. © Published under licence by IOP Publishing Ltd.

Affiliations

Universitas Brawijaya, Malang, Indonesia